Question: How Far From The Utility Line Flags In The Ground Should You Hand Dig?

How long does it take 811 to come out?

Calling 811 is fast.

After you call, professional locators will be sent to the proposed excavation site within 2-3 business days..

How deep do you have to dig to call 811?

There is no allotted depth before a person needs to call 811. Whether you are just planting small shrubs or installing fences, CGA says any time you are putting a shovel in the ground you need to call due to the fact that many utilities are buried just a few inches below the surface.

How deep are residential power lines buried?

24 inchesWorking around buried facilities Main lines are generally found at least 24 inches deep, while service lines are gener- ally found at least 18 inches deep. Keep in mind: existing grades can change and the current depth of an electric or natural gas line may be different than when originally installed.

Can I remove utility flags in my yard?

If locate flags are in place for more than 14 days without any activity, the property owner can remove them because they are no longer valid at that point.

How do I find utility lines in my yard?

811 is the national call-before-you-dig phone number. Anyone who plans to dig should call 811 or go to their state 811 center’s website before digging to request that the approximate location of buried utilities be marked with paint or flags so that you don’t unintentionally dig into an underground utility line.

Is it against the law to dig without calling 811?

The law, in all states, generally provides that anyone excavating must call the 811 utility-locate hotline before digging begins to have all utilities located and marked.

Is it illegal to remove utility flags?

The answer is no, you can’t. You’re better off leaving them alone. Utility flags are placed to avoid any disturbances or accidents in the area as utility work is ongoing. However, if the flag has been there for almost a month without any activity, the property owner may remove them.

What is the proper hand digging method to locate and uncover an existing utility?

Instead, use the following techniques:Use a blunt shovel to loosen the soil, and a regular shovel to remove it.Do not dig straight down, as this will cause damage if you hit the line.Work at an angle so the shovel will slide along the surface of any utility it may contact.More items…

How close can you dig to a power line?

No excavation within 10 metres of a SWER transformer pole is to occur without the approval of the local electricity asset owner. It should be noted that the NSW Service and Installation Rules require a sketch of the underground service/consumers mains to be marked inside the switchboard.

How do you dig around utility lines?

Whenever you hand dig near buried utility lines, take care to prevent damage:Use a rounded or blunt-edged shovel. … Begin digging off to the side of the marked utility line. … Proceed cautiously. … Never pry against a utility line to remove soil. … Dig until you find the actual line, not just a tracer wire or warning tape.